First tongue and groove joint in wood, a long time coming, and a series of steps. Photo 4 by Don Tai
I watch the Woodsmith Shop on OTA TV, and am always amazed at their accuracy and precision. It is not just that they have all the fancy tools, but also that they have tuned their skills to get accurate results. In the reality of my world and my skill I can only approximate their level of expertise. This is my first tongue and groove joint in wood, the result of a long series of steps that took discipline and thinking. As I have no money I have to make do with what I have, which is fine. This is life.
Delta 36-510C table saw has a terrible fence. The fence clamps to an inclined front area, resulting in an inefficient clamp, which moves when you use it.
I have had my Delta 36-510C table saw for quite a long time. The saw is inexpensive and I had very little money and needed a saw. Little did I know at the time that the table fence that came with the saw was terrible. I’d set up the fence, lock it down as tight as possible, and half way through a cut the fence would jiggle free and mess up my cut. I would end up with cut wood with dimensions slightly off at the end. After 15 years of suffering I decided to research and build a DIY table fence that works, is accurate and stays put despite the vibration of the saw.
